GSS HDE 164, Инструкция по сборке

Страница: 7 / 24

- 7 - HDE 164
At the ASI output sockets (BNC) a transport stream is provided according to
ISO/IEC 13818-1.
When the head-end station is switched on, the two-line LC display shows the
"
SETUP " menu and the software version of the control unit.
The control of the module takes place via the control unit of the head-end sta-
tion. To operate the encoder module the software version of the control unit
(head-end station) must be "
V 10 " or higher. The operating software of the
encoder module and the head-end station can be updated using a PC and
the software "
BE-Flash " via the 9-pin D-SUB socket on the head-end station.
You can find the current operating software for the head-end station and the
encoder module, the software "
BE-Flash " and the current assembly instructions
on the website " www.mygss.eu ".
The encoder module is designed exclusively for use in the STC 160 head-end
station.
3 i
nstallation
– Ensure the head-end station is mounted so it will not be able to vibrate.
Avoid, for example, mounting the head-end station onto a lift shaft or any
other wall or floor construction that vibrates in a similar way.
– Before installing or changing a module, switch off the head-end station or
unplug the power cable from the mains power socket.
– Take measures to protect against ESD!
• Open the housing of the head-end station in accordance with the assembly
instructions for the STC 160.