GSS HDE 164, Инструкция по сборке

Страница: 8 / 24

- 8 - HDE 164
3.1 i
nstalling the
e
nCoder module
– When installing a module, make sure that it is inserted in one of the long,
numbered grooves in front of the contact strip on the board at the rear wall
of the housing.
– The shorter, non-numbered grooves without a contact strip on the board at
the rear wall of the housing are for add-on modules only.
• Open the housing of the head-end station in accordance with the assembly
instructions for the STC 160.
• Open the locking device
A
in the direction of the green arrow.
A
• Insert the Encoder module in grooves
B
of an open slot (with contact strip
on the board at the rear wall of the housing) and gently slide it into the
head-end station until it makes contact with the board on the rear wall.
• After installing the Encoder module close the locking device A in the direc-
tion of the red arrow.
—> Ensure that the ground spring C gets contact to the locking device.
C
B
B
A