GSi PNEG-902, Руководство по установке

Страница: 12 / 20

12 PNEG-902 Multi - Module Dryer Stacking
3. Module Preparation and Installation
Installing Support Legs
7. NOTE: This step is not required for a 20' dryer. Use 1/2"-13 x 1-3/4" bolts (S-3883) and 1/2"-13
lock nuts (S-6493) to attach support leg assemblies to rear corners of the dryer frame. Use the grey
shim (D01-1221) to fill the gap between the support leg and dryer frame. On the right side it may
be necessary to remove the cotter pin and slide the clean out door pivot rod forward enough to
insert the top bolt.
(See Figure 3L.)
Figure 3L
8. Use 1/2"-13 x 1-3/4" bolts (S-3883) and 1/2"- 13 lock nuts (S-6493) to attach support legs to hitch
weldment as shown in Figure 3M . Once installed, anchor the support legs to the foundation.
Figure 3M
Left rear support leg
Cotter pin and clean out
Shim
door pivot shaft
Right rear support leg
Support legs may also
be installed here.
Support leg