GSi PNEG-1391, Руководство по сборке и эксплуатации

Страница: 16 / 56

16
Assembly
PNEG-1391 8",10", & 12" BE-SAW Augers
12" Standard Profile Hopper Assembly
A. Attach the rubber hopper wheel to the back of
the swing-away hopper using two (2) 5/8" flat
washers and 3/16" x 2" cotter pins. (See Fig.
2-B)
B. Fasten two (2) hopper caster wheels to front of
hopper using (4) 3/8" x 1-1/4" long (grade 5) hex
head capscrews and nylon locknuts for each
wheel.
FIG. 2-B
The hopper hanger bearing and bearing stub are pre-assembled on the swing-
away hopper. Therefore, in the drawings, those parts were exploded away from
the hopper to better show the proper assembly of the other components.
Tighten locknuts so the flat washers are firmly against the rubber sleeves.
DO NOT tighten so tight that the flat washers are against the flight tube.
Leave about 1/16" gap.
INCLINE
FLIGHT
RUBBER
SLEEVE
LOCKNUT
FLAT
WASHER
TAIL STUB
FLAT WASHER
INCLINE TUBE
5/8" X 1 1/4" LONG
(GRADE 5) HEX HEAD
CAPSCREW WITH
FLATWASHWER AND
NYLON LOCKNUTS
NOTE: INSTALL SO
BOLT HEADS ARE ON
THE INSIDE
COVER
STRAP
3/8" LOCKNUT
INCLINE
FLIGHT
TAIL STUB
HINGED
COVER
RUBBER SLEEVE
U-JOINT
BEARING STUB
BEARING HANGER
CASTER WHEEL
HOPPER FLIGHT
(2) FLAT
WASHERS
3/16" X 2"
LONG
COTTER
PIN
HOPPER
WHEEL
5/16" X 3/4" LONG (GRADE 5)
HEX HEAD CAPSCREWS,
FLATWASHERS AND NYLON
LOCKNUTS
3/8" X 1 1/4" LONG (GRADE 5)
HEX HEAD CAPSCREW AND
NYLON LOCKNUTS
CASTER
WHEEL
C. Remove the incline flight from the incline tube.
D. Attach lower end of the incline tube to the front of
the swing-away hopper. Use two (2) 5/8" x
1-1/4" long (grade 5) hex head capscrews, flat
washers, and locknuts.
E. Connect incline tail stub into the incline flight using
four (4) rubber sleeves, two (2) 1/2" x
3-3/4" long (grade 5) hex head capscrews, flat
washers, and nylon locknuts. (See Fig. 2-A)
FIG. 2-A
2. ASSEMBLE 12” HOPPER AND INCLINE
TUBE ASSEMBLY