PNEG-1020 Bin Sweep Auger
29
Startup
Failures may occur if the auger is run full before it has been “polished” during the “break-in”
period.
NEVER operate the auger empty. Operating augers empty for any length of time will cause
excessive wear.
NEVER operator the auger at speeds higher than recommended. Auger flight speed in excess of
recommended speed causes excessive wear.
Be aware of any unusual vibration or noises during the initial startup and “break-in” period. If
anything unusual is detected, immediately shutdown the auger, and disconnect and lockout the
power supply before servicing.
WARNING
WARNING
WARNING
