21
Instruction
GS 1010
GS Engineering B.V.
manufacturer hydraulic sweepers
When the height of the brush is adjusted in such a way that it
sweeps the sweeping surface for a larger distance, it could result
in increased brush wear. This shortens the life of the brush.
3.3.4 Angle adjustment of the brush
The brush can be placed in an angled position in relation to the direction of
movement. To place the brush in an angled position or release the brush from its
angled position, lift the pin and turn the brush. (see Illustration 1)
Illustration 1
Illustration 2
Lower the pin after that (see Illustration 2). If the pin does not lower completely, turn
the brush slightly until the pin lowers.
The angle of the brush can only be adjusted when the engine is
not running.
3.4 Moving
The machine has its own hydraulic drive. This enables it to make forward and
backward movements.
3.4.1 Operation
To move, it is necessary to keep the appropriate movement handle in a certain
position; the control is the handle located on top of the pushing bar. When the handle
is released, the machine will stop moving immediately. An illustration has been
affixed to the push bar of the machine as shown on the following illustrations.
The GS 1010 has three different movement positions:
