Grundig GSS SMCIP 402 C, Инструкция по сборке

Страница: 36 / 42

- 36 - SMCIP 402 C/T
01/14 A TV X +
• Press button + twice to descramble a station (indi-
cation "X").
• Press the
MODE
button.
—> Return to the "Input parameter" main menu – "
INPUT
".
• Press the
MODE
button.
—> The "Output data rate" – "
DATARATE
" main menu is activated.
o
utPut data r ate
This menu shows the maximum possible output data rate and the current need-
ed output data rate in MBit/s.
OVER
DATARATE
28 / 50.8 OVER
DATARATE
28 / 31.6 OVER
DATARATE
28 / 108
28
: The current needed output data rate.
50.8 : Maximum output data rate DVB-C and ASI at RF+ASI mode
(RF+ASI mode; dependent on the output parameter settings).
31.6 : Maximum output data rate DVB-T and ASI at RF+ASI mode
(RF+ASI mode; dependent on the output parameter settings).
108 : Maximum output data rate at ASI mode (modulator off).
If the station filter is set correctly, the current needed data rate is at least 10%
less than the maximum data rate. The value fluctuates, since the data rates of
individual stations are dynamically modified by the broadcasters.
—> Is the current needed data rate higher than the maximum data rate
" OVER " appears in the display. In this case correct the output pa-
rameter settings (DVB-C page 22 / DVB-T page 24) or the settings of the
station selection (page 34).
OVER
DATARATE
75 / 50.8 OVER
DATARATE
75 / 31.6 OVER
DATARATE
112 / 108
• Press the
MODE
button.
—> The "Transport stream ID and ORGNET-ID" – " TS/ONID " main
menu is activated.