![Grundig GSS SMCIP 402 C Скачать руководство пользователя страница 34](http://html1.mh-extra.com/html/grundig/gss-smcip-402-c/gss-smcip-402-c_assembly-instruction-manual_2273298034.webp)
- 34 -
SMCIP 402 C/T
i
nPut
frequenCy
In this menu you set the input frequency of the desired transponder in MHz.
FREQ
CN 9
A
11244 -1.8
Once the RF receiver has synchronised to the input signal, any offset to the
target frequency is displayed in MHz, e.g. "
– 1.8
".
If a question mark "
?
" appears in the second line of the display, there is no
input signal present. In this case check the configuration of the antenna system
as well as the preceding settings of the device
• Use
</>
to position the cursor under the digit of the frequency displayed to
be set.
• Press
+/–
to set the respective digit of the input frequency needed.
• Repeat the procedure by the quantity of the digits to be set.
• Set the frequency offset shown in the display (e.g. "
– 1.8
") to less than
1 MHz ("
± 0.x
") by varying the input frequency using the
+/–
buttons.
Signal to noise ratio:
"CN …" indicates the current signal to noise ratio, in order to estimate the
quality of the input signal.
• Press the
MODE
button.
—> The "station selection" submenu – e.g. "
TV
" is activated.
o
Per ation
with
a
Ca
module
In order to descramble scrambled channels a corresponding smart card is
needed.
The channels to be descrambled are set in submenu "station selection".
s
tation
seleCtion
In this menu you select the stations (services), which shall be inserted into the
"new" transponder.
Herein you select which scrambled station should be descrambled using an
adequate CA module.
Содержание GSS SMCIP 402 C
Страница 1: ...Assembly Instruction SMCIP 402 C T...