Grundig GCH-K0274P, Руководство пользователя

Страница: 27 / 40

ALARM PIN:
The dome provides 4 alarm inputs and
2
output
s
(N.O. or N.C.). Select an alarm connector of which you want to set
the alarm-related parameters, and then set its alarm-related parameters in the Alarm Setting menu. For alarm
pin definitions, please refer to chapter 4.7. Alarm Application.
NOTE: If two or more alarm pins are triggered at the same time, a smaller alarm pin number will have higher
priority of being handled. For example, if Alarm-1 and Alarm-3 are triggered simultaneously, only Alarm-1 will
actually be handled.
ALARM SWITCH:
This item is used to enable or disable the selected alarm pin function. Use the LEFT/RIGHT direction keys on the
control keyboard to change the setting.
ALARM TYPE:
There are two kinds of alarm types: Normal Open and Normal Close, which are illustrated below. Select an
alarm type that corresponds with your alarm application.
ALARM ACTION:
The alarm actions include PRESET, SEQUENCE, AUTOPAN and CRUISE functions. Select one of these modes for
a certain action to be executed when an alarm is triggered. Use the RIGHT direction key of the control keyboard
to select a particular action mode. The items listed below will change according to your selected alarm action.
Additionally, when an alarm is triggered, there the flash warning notice "ALARM" will be displayed in the upper
right corner of the screen.
NOTE: After an alarm condition (Dwell Time Setting: 1~127 seconds/ ALWAYS) was released, the Dome Camera
will go back to the previous status before an alarm was triggered.
- PRESET POINT:
Select a Preset Point to which the Dome Camera should go when an alarm is triggered. The preset point(s)
should be set in advance, either in the PRESET setup menu or through the keyboard.
- SEQUENCE LINE:
Select a Sequence Line that the Dome Camera should execute when an alarm is triggered. The sequence line(s)
should be defined in advance, either in the SEQUENCE setup menu or through the keyboard.
- AUTOPAN LINE:
Select an Auto Pan Line that the Dome Camera should execute when an alarm is triggered. The Auto Pan Line(s)
should be defined in advance, either in the AUTOPAN setup menu or through the keyboard.
- CRUISE LINE:
Select a Cruise Line that the Dome Camera should execute when an alarm pin is triggered. The Cruise Line(s)
should be defined in advance, either in the CRUISE setup menu or through the keyboard.
25 English