page 17
b)
Lubricus Controller Exit 1, orange LED is blinking (-> right side of Lubricus body)
Same procedure like a) …
-
Automatic change to next
Lubricus Controller exit 2, 3 and 4 see Adjustment Flow chart, page 9
c)
If no further action the unit will continue in the operating mode. Place activation and programming key in
ventilation hole and turn it from OPEN -> CLOSE
d)
Lubricus Controller will initiate all activated exits. The display will change to “ON”. An extra lubrication cycle of
0.15 cc per exit with back pressure measurement (Quick check) will be performed. A value that represents the
pressure required to pump the lubricant to the lubrication point will be displayed. After the pump cycle is
finished the max pressure is shown in bar, e.g. 015 represents 15 bar. The unit can only provide approximate
values from + / - 15 %. This is accurate enough to establish the condition of the lubrication point.
(5)
Additional functions: QuickCheck = extra dispensing cycle
(= pumping of small amounts of lubricant for
testing purposes):
Touch
contact sensor of Lubricus Controller with programming key and count
2 x red blinking
signal
(central LED in the display)
(6)
Additional functions: Switch „OFF“:
Touch
contact sensor of Lubricus Controller with programming key and count
3 x red blinking signal
(central
LED in the display) and remove programming key. Display changes to “OFF”. Adjustment stays in Memory. A
longer contact of the programming key with the sensor does not switch the unit off preventing accidental stopping
when a strong magnet is near the of Lubricus Controller.
(7)
Additional functions: Switch „ON“:
To switch the unit “ON”
Touch
contact sensor of Lubricus Controller with
programming key and count
3 x red blinking signal
(central LED in the display) and remove programming key.
Display changes to “ON”. Adjustment stays in Memory
