88
Revision date: 12.17.14
1
8. If using the 113074 brackets to plumb the gutter on frame, align brackets with slope lines on each rafter (previous page). Attach brackets every 48" using
two (2) FA4482B Tek screws for each. Next, attach customer-supplied 1" x 4" ribbon board to each 113074 bracket using two (2) FA4484B Tek screws.
Countersink Tek screws in ribbon board for best results. To prevent conflicts with gutter bracket installation,
install screws so they are 1-1/2" below the top
of ribbon board
. Ribbon board runs along building end-to-end. Extend ribbon board past end rafter at drain end to allow for gutter install beyond frame.
Sample Frame with 113074 Bracket:
Attach ribbon board to the bracket.
Sample Frame without 113074 Bracket:
Attach ribbon board directly to rafter.
If rafters are straight where the gutter will be installed, 113074 brackets are typically not used. Attach customer-supplied 1" x 4" ribbon board to rafters
using FA4484B Tek screws. Countersink heads of screws below board surface for best results. Install screws
so they are 1-1/2" below top of ribbon board
to prevent interfering with the vinyl gutter bracket installation.
Align ribbon board with slope lines to set required gutter slope from end-to-end.
Assembly Instructions
Rafter
113074
Customer-
Supplied
Ribbon
Board
No
screws
here.
Building Cover
30'-0"
CONCRETE PIER
GROUND LEVEL
CONCRETE PIER
12"
12"
No
screws
here.
Building Cover
Rafter
Customer-
Supplied
Ribbon
Board
Customer-supplied ribbon board for gutter
extends past frame to allow for installation
of drop outlet and downspout.
Attach brackets and gutter to ribbon board.
RAINWATER CATCH DRAIN INSTALLATION (continued)
