GROWSPAN
™
ROLLING PREMIUM HIGH TUNNELS
4
Revision date: 01.01.16
REQUIRED TOOLS
The following list identifies the main tools needed to
assemble the shelter. Additional tools and supports may be
needed depending on the structure, location, and
application.
• Tape measure or measuring device
• Fine point marker to mark the location on tubing.
• Variable speed drill and impact driver (cordless with
extra batteries works best)
• Wrench, ratchet, and socket set (recommended)
• Hex wrench set to secure end frame fittings
• Scissors, box cutter, or utility knife
• Ropes long enough to reach over the frame. May not
be needed depending on number of assistants and lifts.
• Hammers and gloves
• Duct tape (supplied)
• Ladders, work platforms, and other machinery for lifting
designed to work safely at the height of the frame
UNPACK AND IDENTIFY PARTS
The following steps will ensure that you have all the
necessary parts before you begin to assemble the shelter
frame.
1. Unpack the contents of the shipment and place where
you can easily inventory the parts. Refer to the Bill of
Materials/Spec Sheets.
2. Verify that all parts listed on the Bill of Materials/Spec
Sheets are present. If anything is missing or you have
questions, consult the Pictorial Parts Guide and all
diagrams for clarification, or contact Customer Service.
NOTE:
At this time, you do not need to open the plastic
bags containing smaller parts such as fasteners or
washers (if equipped).
PARTS IDENTIFICATION
The following graphics and photos will help you identify
the different parts. (Some parts are not shown.)
FA4482B
Tek Screw
102857
End Clamp
102547
Cross Connector
103544
Mounting Plate
102569
Bearing
102717
Gearbox Drive
103496
Gearbox
102198
U-Channel Spring
102197
Poly Latch U-Channel
102570
Aluminum Channel
CC6212 &
CC6214
Fabric Clips
QH1400 &
QH1404
10015108
10016208
10015808
