25
GROWSPAN
™
ROLLING PREMIUM HIGH TUNNELS
Revision date: 01.01.16
END FRAME ASSEMBLY
Consult the diagram below and the details in the Quick Start section to assemble and install the end frames.
Gather the parts:
• 10015108 (1.90" Short Tee Fitting), 10015808 (1.90" Short Cross Fitting), 190P099 pipe, and 190P096 pipe
• QH1400 and QH1404 band clamps
• 103937 Stake with Strap (Strap is not used to secure end frame.)
• Lifts, ladders, tools, and assistants
Assemble and Install the End Frames
1. Use the diagram to assemble the end wall. For best results, begin along one side and work toward the other side of
the end wall. The 10016208 swivel sockets were attached to the cross beam brace of both end rafters during the end
rafter assembly. If the step was overlooked, loosen the cross beam brace to install the swivels and continue.
2. Anchor the end wall frame to the site by driving a stake next to each vertical and securing it with the band clamps.
Use the diagram details as guides. Unlike the stakes used to anchor the main frame,
the stakes for the end frame
must be removed and reused when the frame is moved
.
NOTE:
To prevent injury,
you must anchor the end wall frame before installing the end panel
.
3. After assembling and anchoring both end frames, continue by installing the end panels.
10016208
10016208
10016208
10016208
190P099
190P099
190P096
Cross Beam Brace
190P096
190P099
10015108
10015808
