19
GROWSPAN
™
ROUND PREMIUM GREENHOUSES
Revision date: 01.10.19
106201_02_03_04
6. With panel secured in place, cut it to size.
Use rafter
as a guide when cutting top.
ATTENTION:
Skip this step if desired and complete it
once
all panels are installed
. Review flashing and roof
panel installation steps later in this guide to determine
end panel length. Panel to remain flush with top of end
rafter pipe.
7. Take the 4' x 8' panel and cut a section to cover above
door. Prepare as previously described. Remember to
account for installation of adjacent panel and H-channel
between panels. Actual frame may differ.
8. After cutting panel to proper width, measure and cut
two sections of H-channel to correct length. H-channel
is used to join two separate panels.
Install H-channel
with flat side out.
9. Install one section of H-channel along each panel
edge. Install H-channel flush with panel bottom.
Install
panel with UV-protected side out.
10. Measure between
edges of H-channel
at panel bottom
and cut a section of end cap profile (104548) to fit
between H-channel.
END PANEL INSTALLATION (continued)
11.
Install end cap profile on bottom of small panel.
When
installed, it will overlap top of door frame.
12. Using Tek screws (no washers), secure panel in place
above door by installing a screw through center of
H-channel and into frame member. Install flat side out.
Install UV-protected side of panel to the outside.
Secure end panels to all vertical end frame tubes using
FA4484B screws and 102921B washers.
Measure Width
(center-to-center)
End Cap
104548
H-channel: Install
flat side out.
Trimmed polycarbonate panel
above the door.
NOTE:
H-channel to remain below top of rafter and
short enough to allow for installation of flashing.
13.
Repeat steps to prepare and install final 6' x 10' panel
for this end wall.
5. Attach panel (taped end down) to vertical end wall
framing using FA4484B Tek screws and 102921 neo-
bonded washers. Consult End Panel diagrams.
Space
screws evenly at 16".
ATTENTION:
Do not
secure panel to end rafter. Doing
so will interfere with flashing installation.
Cut from a 4' x 8'
panel.
Install H-Channel
here.
