10
NOTE:
When raising the undercarriage, properly guide the hoses to avoid pinching them between the
tractor frame and the undercarriage.
NOTE:
When jacking up the undercarriage, make sure to not jack too high or you may hit other parts of
the tractor.
32.
Place jacks under the undercarriage in the
front and in the back. The use of a block in the
front will ensure that both arms are raised at the
same time (1). Lift until the undercarriage holes
line up with the holes on the tractor bracket.
33.
Verify that the control valve hoses are
positioned over the top of the undercarriage
arm (1).
Installing Undercarriage
34.
Once the front holes are aligned, insert two
5/8” x 2-1/2” bolts (1) (PN: 16-20190) with a 2 hole
washer (2) (PN: 57-11324) into the left and right
undercarriage arms. The washer is installed on the
outside of the undercarriage arm.
35.
Install a 2 hole washer and two 5/8” center lock
nuts (PN: 70-20606) on the bolts.
NOTE:
Do not tighten until all mounting
bolts have been installed.
2
1
Avoid injury! Watch for pinch points
when raising the undercarriage.
Caution
!
!
1
1
36.
Continue lifting the rear of undercarriage until
the holes on the undercarriage line up with the holes
on the tractor bracket (1).
1
