11
37.
For each side, insert two 5/8” x 2-1/2”
bolts (1) (PN: 16-20190) with a 2 hole washer
(2) (PN: 57-11324). The washer is to be on
the outside of the undercarriage. Insert the
bolts so the head is facing the inside of the
tractor.
38.
Put a 2 hole washer (1) (PN: 57-11324)
and a 5/8” center lock nut (2) (PN: 70-20606)
on the bolts. These will be on the outside of
the tractor as shown in the pictures.
39.
Torque all fasteners to the correct
specifications after all 8 bolts and nuts have
been installed.
2
1
2
1
NOTE:
If the tractor has 4 wheel drive,
a cable is under the engine located by the
drive shaft. Attach this cable to the tractor
with zip ties to prevent it from catching on the
Belly Blade.
Installing Valve Bracket Support (Factory Loader)
41.
Attach valve support bracket (1) (PN: 18-11454) onto
back side of loader bracket on the right side of the tractor
with a 1/2” x 1” bolt (16-20124) and a 1/2” nut
(PN: 70-20584). Install bolt from inside the loader bracket
and the nut on the valve support side.
NOTE:
View of Bolt Head (1)
1
1
40.
Reinstall tires on the tractor, remove jacks,
and lower the tractor. The undercarriage
installation is complete.
NOTE:
If tractor does not have a loader,
skip to Step #42 on Page 12. If tractor has
a loader, continue with Step #41.
