Gröne 2530-442200, Руководство пользователя

Страница: 33 / 200

33
The tool is also equipped with an electronic speed stabiliser which maintains the set revs when the tool
is loaded. In case of overload a separate safety system will shut down the engine. In such situation, re‑
lease the on switch and restart the tool. Before you resume work, keep the tool switched‑on for about
2 minutes without load to let the engine cool down to proper temperature.
E
2
Fig. 10
Due to high risk of accident of working with the grinder, the device does not have the continu‑
ous operation button.
The user is obliged to perform work while focused and to follow occupational
safety and health rules as well as safety notices contained in the manual.
It is only possible to work with a locked on‑switch during work with a grinder mounted
on the cart.
Switching off
To switch off the tool, release the on switch (2) (Fig. 10), or if working with a cart, by using an off‑switch
(D) (Fig. 9).
After the working tool and accessories have been properly mounted, you can start work.
Before you start work make sure to conduct the test of settings and mounting of working ele‑
ments by conducting test grinding on test material.
After work is done, switch off the tool and wait until the abrasive wheel stops completely. Risk
of bouncing off, material recoil or abrasive wheel damage.
WORKING IN CORNERS AND WITH EDGES OF SURFACE
Remove the power cord from the socket before assembly / disassembly of front shroud!
The grinder allows you to work easily and precisely in corners or on the edges of processed surfac‑
es. To switch this working mode, press two mounting clips (F) located in the front part of the grinder
shroud. After the clips have been pressed, the lock will be released and the half‑moon door (G) can be
removed. It features a built‑in magnet which allows it to be mounted on the tool’s casing while working
(Fig. 11).