Grohe F-DIGITAL DELUXE 36 371, Руководство по установке

Страница: 34 / 65

DIE
®
Tank
Steam
Generator
Water
Level
Probe
Electric Water
Solenoid Valve
Shutoff Valve
Union
(Required)
IMPORTANT: Install
steamhead 18" above
the shower floor or 6"
above the rim of the
bathtub.
Optional Auto Drain Valve
Connect to Indirect Waste
or As Required by Local Codes.
Cold Incoming
Water Supply
120 PSI max
Steam Line
Pressure Safety Valve
Connect to Indirect Waste
or As Required by Local Codes.
Plumbing Installation Instructions
3.
Steam Generator Installation
The Steam Generator should be mounted in a location conve-
nient for hook-up and service by the plumber and electrician.
CAUTION:
The Steam Generator is designed to be used
ONLY in an upright and level position; to do otherwise would
damage the unit and void the warranty.
a) The Steam Generator can be mounted to a wall or set
on the floor. However, the unit must be secured. To
secure the unit to a vertical wall, loosen the two
screws holding the electrical access cover, remove
cover (see Figure 1). Located inside the cabinet near
the top left and right corners are mounting holes.
Place top cover back and secure.
Figure 2 - Plumbing Diagram
Installation Instructions Models: SM5, SM-7 and SM-9
09/12
Pub. No. 279-E
- 2 -
b) Connect the ⅜ " water inlet to a shut off valve as
described in Section 2.a. The valve must be kept
in an open position during normal operation. In an
area where water hammer is a problem install a
water hammer arrestor in the line. Refer to Figure
2.
IMPORTANT:
Do NOT use a “saddle valve” or
piercing type valve for water connection.
c) Connect the steam line from rough-in location
described in Section 2 to the ¾" nipple on the
Steam Generator using a union.