Grohe F-DIGITAL DELUXE 36 371, Руководство по установке

Страница: 5 / 65

86
External interface
Via the external interface the Bluetooth
®
adapter can be
rebooted or resetted. It is adapted as a break contact, which
can be used with conventional nc (normally closed) type
switches or push buttons.
1. Turn the entire system free of voltage.
2. Remove Bypass (C), see fold-out page I.
3. Connect switch or push button with cable 47 868 000
(special accessorie) to the external interface
(max. 16.4 ft [5m]).
4. Supply the entire system with voltage.
If the external interface is not used, the bridging contact
must remain plugged in!
Pairing
Pairing means the first coupling between two Bluetooth
®
devices. This requires a proper executed installation. For an
already active
Bluetooth
®
connection between a terminal
device and the Bluetooth
®
adapter no pairing is possible.
1. Activate Bluetooth
®
on device.
2. Select xxx Grohe SPA from Bluetooth
®
list.
xxxx is the 4-digit number (PIN number) which will be
displayed.
3. Enter PIN number and confirm.
4. Connection will established automatically.
5. The LED (A) on the adapter flashes 1x blue for a short time
when connection is quite correct.
The PIN number is unique for each adapter and is additionally
documented with a sticker on the backside. These are the last
four digits of the serial number.
The PIN number can not be
changed!
When successfully paired, the PIN is no longer required when
a new connection attempt. When connected and activated the
App LED on the adapter lights up blue continuously. A
maximum of 8 devices can be paired. When logging a 9th
device the most rarely used one will be deleted from the list.
XXXX
Operation of the reset button (A) and Visualization by status LED (B)
Functions
Function Visualization
Operation takes place
LED lights permanently blue
Reboot of the adapter LED lights up red for 3 sec.
Reset of the adapter LED lights up red, off, red, blue, red
Ready for operation LED off
Modul is supplied with voltage LED lights up red for 1 sec.
Permanent press of button, or
bridging contact removed LED flashes red
Function Describtion
Changing the device Device will be logged out (connection closed/inactive).
After 10sec. the new device can be logged in.
Prioritization of connections
It will be ensured that the operation can take place only with a single device
at any time.
Visibility of the
Bluetooth
®
adapter
The Bluetooth® adapter is always visible.
Reboot the
Bluetooth
®
adapter
(Entire system turns off)
Press the button shortly (less than 3 sec.):
- Connection will be interrupted
-
Bluetooth
®
adapter reboots
- System shuts down (Music, light (max. 60sec. delay), steam)
Reset of the
Bluetooth
®
adapter
(Entire system turns off)
Press and hold the button (between 10 and 20sec.):
- Connection will be interrupted
- Pairing list will be cleared
-
Bluetooth
®
adapter reboots
- System shuts down (Music, light (max. 60sec. delay), steam)
Data transfer As soon as a device is connected, the system can be operated using the
Grohe App.
Audio stream As soon as a device is connected, an audio stream can be sent to the
system by the Grohe App.
A
B
C