4
Maintenance
Shut off hot and cold water supply.
Inspect, clean and, if necessary, replace parts.
I. Battery
Batteries which are almost discharged are indicated by a
flashing indicator lamp.
1. Fit cleaning clip (K), see Fig. [7].
2. Remove screw (L) and detach housing (M), see Fig. [8].
3. Detach protective sleeve (N) and remove battery(O), check
contacts, clean and if necessary replace.
Assemble in reverse order.
II. Solenoid valve
1. Proceed as for maintenance of battery, points 1 to 3.
2. Remove screws (P1) and detach battery tray (P),
see Fig. [9].
3. Detach plug-in connection (R) and remove solenoid
valve (S) by turning clockwise using a 5mm allen key,
see Fig. [10].
4. Remove filter (T).
Install in the reverse order observing the installation position.
III. filter
1. Unscrew connection hose and remove adapter (C),
see Fig. [11].
2. Remove filter (B).
Assemble in reverse order.
IV. Remove mousseur (13 220) using a spanner and clean
Assemble in reverse order.
V. Mixer spindle
1. Disconnect fitting from connections.
2. Remove fitting from wash basin. Disassembly is as
described in section "Setting temperature limiter",
see Figs. [5] and [6].
3. Remove screw (U) from housing using a 2.5mm allen key,
see Fig.[12].
4. Pull out mixer spindle (G).
Assemble in reverse order.
Screw (U) must engage in groove (G1) of mixer
spindle (G).
Replacement parts
, see fold-out page I (* = special
accessory)
Care
For directions on the care of this fitting, please refer to the
accompanying Care Instructions.
Disposal note
Dispose of batteries in accordance with national
regulations!
Fault/ Cause/ Remedy
Fault
Cause
Remedy
Water not flowing
• Water supply interrupted
- Open shut-off valves, service valves
• Filter upstream of solenoid valve blocked
- Clean, see Maintenance, Solenoid valve
• Solenoid valve defective
- Replace, see Maintenance, Solenoid valve
• Plug-in connector of solenoid valve without
contact
- Attach plug-in connector
• Battery discharged
- Replace, see Maintenance, Battery
• Hands not in reception range
- Hold hands directly under the spout
Indicator lamp
flashing
• Battery almost discharged
- Replace, see Maintenance, Battery
Water flowing
continuously
• Solenoid valve defective
- Replace, see Maintenance, Solenoid valve
Undesired water flow
• Sensor system detection zone set too high
for local conditions
- Reduce range using remote control (special
accessory, Prod. no.: 36 206)
Flow rate too low
• Filter or mousseur dirty
- Replace, see Maintenance, Filter and Mousseur
• Service valves not fully open
- Fully open shut-off valves, service valves
• Water supply restricted
- Check supply lines, open service valves
Mixing device
incorrect
• See “Flow rate too low”
• Limescale on mixer spindle
- Clean, see Maintenance, Mixer spindle
• Temperature limiter incorrectly set
- Setting, see "Setting temperature limiter"
