OM-AHS
11
When attaching the draw-off valve, just
hand-tighten the nut.
Cleaning
1.
Suggested Cleaning Supplies
a. Cleaner, such as Klenzade HC-10 or HC-32
from ECOLAB.
b. Kettle brushes in good condition.
c. Sanitizer such as Klenzade XY-12.
d. Film remover such as Klenzade LC-30.
2. Precautions
Before any cleaning, shut off the kettle by turning
the thermostat dial to "OFF" and the On/Off switch
to Off .
WARNING
KEEP WATER AND SOLUTIONS OUT OF
CONTROLS AND BURNERS. NEVER SPRAY OR
HOSE THE CONTROL CONSOLE, ELECTRICAL
CONNECTIONS, ETC.
3. Procedure
a. Clean food contact surfaces
as soon as
possible after use, preferably while the kettle
is still warm. If the unit is in continuous use,
clean and sanitize inside and outside at least
once every 24 hours.
b. Scrape and flush out large amounts of food
residues. Be careful not to scratch the kettle
with metal implements.
CAUTION
NEVER LEAVE A SANITIZER IN CONTACT WITH
STAINLESS STEEL SURFACES LONGER THAN 30
MINUTES. LONGER CONTACT CAN CAUSE
CORROSION.
c. Prepare a solution of the detergent/cleaning
compound as instructed by the supplier.
Clean
the unit thoroughly. A cloth moistened
with cleaning solution can be used to clean
controls, housing, electrical conduit, etc.
b. Rinse the kettle thoroughly with hot water.
Then drain completely.
c. Disassemble the tangent draw-off valve. Clean
the draw-off port and each valve part with a
brush.
CAUTION
DO NOT MIX PARTS OF DIFFERENT DRAW-OFF
VALVE ASSEMBLIES. THE PARTS ARE NOT
INTERCHANGEABLE.
d. Rinse the kettle and draw-off valve parts
thoroughly with hot water, then drain
completely.
e. When you reassemble the draw-off valve,
hand-tighten
the nut which holds it in place.
CAUTION
MOST CLEANERS ARE HARMFUL TO THE SKIN,
EYES, MUCOUS MEMBRANES AND CLOTHING.
PRECAUTIONS SHOULD BE TAKEN TO WEAR
RUBBER GLOVES, GOGGLES OR FACE SHIELD
AND PROTECTIVE CLOTHING. CAREFULLY READ
THE WARNINGS AND FOLLOW LABEL
DIRECTIONS.
f. As part of the daily cleaning program, clean all
inside and outside surfaces that may have
been soiled. Remember to check such parts as
the underside of the cover, control housing, etc.
g. To remove materials stuck to the equipment,
use a brush, sponge, cloth, plastic or rubber
scraper, or plastic wool along with the
e. Groen Spray Degreaser (P/N 114801)
f. Groen delimer/descaler (P/N 114800)
Содержание AHS-40
Страница 16: ...16 Parts List AHS...
