Grizzly T33150, Руководство пользователя

Страница: 28 / 40

-26-
Model T33150/T33151 (Mfd. Since 03/22)
SECTION 6: MAINTENANCE
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Always wear a respirator,
safety goggles, and gloves
when cleaning the filters.
Sawdust may cause allergic
reactions or respiratory
problems.
Schedule
For optimum performance from this machine, this
maintenance schedule must be strictly followed.
Ongoing
To minimize your risk of injury and maintain proper
machine operation, shut down the machine imme-
diately if you ever observe any of the items below,
and fix the problem before continuing operations:
• Loose or damaged mounting hardware.
• Dirty or clogged filters.
• Worn or damaged wires.
• Any other unsafe condition.
Cleaning/Replacing
Filters
The volume of air filtered has a direct correlation
to when you must clean or replace the filters.
To maintain efficient operation, check the filters
approximately every 40 hours of use in light or
moderately dusty environments. In very dusty
environments, check the filters every eight hours
of use. Always wear a respirator when checking
the filters.
Items Needed Qty
Vacuum ............................................................ 1
Gloves ........................................................1 Pair
Dust Mask/Respirator ........................................ 1
Safety Goggles ...........................................1 Pair
Flat Head Screwdriver ....................................... 1
To clean and replace filters:
1. DISCONNECT MACHINE FROM POWER!
2. Remove pre-filter from intake side of machine
(see
Figure 24).
Tip:
Use flat head screwdriver to gently pry
bottom of filter up to remove it, being careful
not to damage filter.
Figure 24. Location of pre-filter.
After 300 hours of run time, the Filter 1 light will
turn red to indicate that the HEPA filter needs to
be replaced. After 600 hours of run time, the Filter
2 light will turn red to indicate that the activated
carbon filter needs to be cleaned/replaced. The
lights are blue when the filters are in normal state.
Pre-
Filter