Grizzly G1033X, Руководство пользователя

Страница: 40 / 76

-38-
Model G1033/X/Z (Mfd. Since 02/19)
Tensioning/
Replacing V-Belts
To tension/replace V-belts:
1. DISCONNECT MACHINE FROM POWER!
2. Remove V-belt cover from left side of machine
to expose belts, as shown in Figure 47.
Note: A collection of black belt dust at the
bottom of the belt cover is normal during the
life of the belts.
Figure 47. Example of belt cover removed to
expose V-belts and pulleys.
V-Belts
Cutterhead
Pulley
Motor
Pulley
3. Remove front cabinet cover to access motor
mount hex nuts (see Figure 48).
Figure 48. Front cabinet cover removed to
access motor mount hex nuts.
Motor Mount
Hex Nuts
After approximately 16 hours of operation,
V-belts will stretch and seat into pulley
grooves and need to be properly tensioned
to avoid severely reducing life of V-belts.
Three V-belts transfer power from the motor to the
cutterhead, and then to the infeed and outfeed
rollers with the use of the drive chain system. To
ensure efficient transfer of power to these sys-
tems, make sure the V-belts are always properly
tensioned and in good condition.
If the V-belts are worn, cracked, or damaged,
replace them. Always replace all V-belts at the
same time with a matched set of three, or belt
tension may not be even among the belts, causing
premature belt failure.
V-belts and pulleys will be hot after opera-
tion. Allow them to cool before handling.
Items Needed Qty
Phillips Screwdriver #2 ...................................... 1
Open-End Wrench 19mm .................................. 1