Grizzly G1033X, Руководство пользователя

Страница: 35 / 76

Model G1033/X/Z (Mfd. Since 02/19)
-33-
Feed Roller Bushings
Oil Type ................ SB1365 or ISO 68 Equivalent
Oil Amount .......................................... 2–3 Drops
Frequency ................ Every 8 Hours of Operation
Table Height Worm Gear
Grease Type ......... T26419 or NLGI#2 Equivalent
Frequency ............ Every 160 Hours of Operation
Columns & Leadscrews
Oil Type ................ SB1365 or ISO 68 Equivalent
Oil Amount ............................................Thin Coat
Grease Type .......................... NLGI#2 Equivalent
Frequency .............. Every 40 Hours of Operation
Figure 41. Dust sleeve removed to expose
column and leadscrew for lubrication.
Column
Leadscrew
Figure 40. Lubrication locations for feed roller
bushings.
Lubricate
Here
Table Height Chain & Sprockets
Grease Type ......... T26419 or NLGI#2 Equivalent
Frequency ............ Every 160 Hours of Operation
Figure 43. Table height chain and sprockets as
viewed from underneath the base.
Figure 42. Location of table height worm gear
housing.
Worm Gear
Housing
Cap Screws
(1 of 3)
The infeed and outfeed rollers rotate inside bush-
ing blocks on both ends of the rollers. Add 2–3
drops of ISO 68 machine oil to the center hole of
the four feed roller tension adjustment bolts on top
of the head casting, as shown in
Figure 40.
The table rides on the columns and is moved by
the rotation of the leadscrews inside the columns.
Loosen the dust sleeve to access the columns
and leadscrews (see
Figure 41). Apply a thin coat
of ISO 68 machine oil to the outside surface of the
columns and brush on a light application of multi-
purpose grease to the leadscrew threads. Move
the table up and down to distribute the lubricant.
Remove the three cap screws that secure the
worm gear housing (see
Figure 42), then lift
the housing and handwheel assembly off the
machine. Clean away any debris from the housing
and gears, then brush on a moderate amount of
multi-purpose grease to the gear teeth.
The table leadscrews are synchronized by the
table height chain and sprockets located under-
neath the planer base (see
Figure 43). Use shop
rags and mineral spirits to clean away debris and
grime, then brush a light coat of multi-purpose
grease onto the chain and sprockets.