Grizzly G1033X, Руководство пользователя

Страница: 21 / 76

Model G1033/X/Z (Mfd. Since 02/19)
-19-
Dust Collection
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
To connect the machine to a dust collection sys-
tem, fit a 5" dust hose over the dust port, and
secure in place with a hose clamp (see
Figure 17).
Tug the hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
Figure 17. Example of dust hose connected to
dust port.
Minimum CFM at Dust Port: 600 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Checking Gearbox
Oil Level
Before starting your machine for the first time,
check the gearbox oil level. The proper oil level is
just even with the bottom of the fill plug hole. The
gearbox uses ISO 320 gear oil. SAE 140 or SAE
85W–140 are acceptable alternatives if ISO 320
is not available. DO NOT mix oil types.
Note: For easier access to the fill plug, remove
the drive chain cover (see
Figure 18).
To check gearbox oil level:
1. Remove gearbox oil fill plug (see Figure 18).
2. Wipe clean the 6mm hex wrench that came
with your machine, dip the short end of it
inside fill hole, and then remove it.
— If the end of the hex wrench is coated
with oil, then the gearbox oil level is okay.
Replace the fill plug and continue setup.
— If the end of the hex wrench is not coated
with oil, then you need to add more oil.
Refer to
Gearbox Oil on Page 34 for
instructions on how to do this.
Note: We recommend that you replace the gear-
box oil after the first 20 hours of operation. This is
a normal break-in procedure and will help maxi-
mize the service life of the machine by flushing
away any particles from the break-in and manu-
facturing process.
Figure 18. Location of gearbox oil fill plug.
Fill Plug
Drive Chain
Cover