-24-
Model G1033/X/Z (Mfd. Since 02/19)
Depth of Cut
Pitch & Glue Build-up
Problem: Glue and resin buildup on the rollers
and cutterhead will cause overheating by decreas-
ing cutting sharpness while increasing drag in the
feed mechanism. The result can include scorched
lumber, uneven knife/insert marks, and chatter.
Solution: Clean the rollers and cutterhead.
Chip Marks or Indentations
Problem: Chip indentation or chip bruising is the
result of wood chips not being thrown away from
the cutterhead and out of the machine. Instead
they are carried around the cutterhead, deposited
on the planed surface and crushed by the outfeed
roller. Some of the causes of chip indentation are:
•
Wood chips/sawdust not being properly
expelled from the cutterhead.
•
The type of lumber being planed. Certain
species have a tendency to chip bruise.
•
A high moisture content (over 20%) or surface
moisture (refer to
Workpiece Inspection).
•
Dull knives/inserts.
•
Excessive depth of cut.
Solution:
•
Use a proper dust-collection system; adjust
chip deflector in or out as necessary.
•
Lumber must be completely dry, preferably
kiln-dried (KD). Air-dried (AD) lumber must
be seasoned properly and have no surface
moisture. DO NOT surface partially-air-dried
(PAD) lumber.
•
Make sure planer knives/inserts are sharp.
•
Reduce depth of cut.
Rippled Cut
Problem: Regularly spaced indentations across
face of workpiece are caused by excessive out-
feed roller pressure or excessive feed rate.
Solution: Reduce outfeed roller pressure; reduce
feed rate.
Figure 21. Location of depth-of-cut controls
(G1033X shown).
Depth-of-Cut
Indicator &
Scale
Table
Height
Handwheel
Table Movement
One Full Revolution of Handwheel .................
1
⁄
16
"
Material Thickness Range
Minimum–Maximum Stock Thickness ......
1
⁄
4
"–8"
The depth of cut on a planer means the amount
of material that is removed from the top of the
workpiece as it passes underneath the cutterhead.
The depth of cut is set by adjusting the distance
of the table below the cutterhead. This distance is
the thickness of the workpiece minus the depth of
cut. The planing depth of cut is controlled by using
the table height handwheel on the right side of
the machine. Rotating the handwheel clockwise
raises the table.
Although the correct depth of cut varies accord-
ing to wood hardness and workpiece width, we
recommend the maximum depth of cut (per pass)
be no more than
1
⁄
16
". A series of light cuts will
give better end results and put less stress on the
planer than trying to take off too much material in
a single pass.
The depth of cut can be referenced directly from
the scale on the front of the planer, as shown in
the figure below.
Note: The scale functions as a general guide only,
and is not intended for low-tolerance, precision
results. To ensure accuracy, use a tape measure
or caliper to measure your workpiece thickness
after each pass.
Содержание G1033X
Страница 76: ......
