Grizzly G1015, Руководство пользователя

Страница: 26 / 40

-24-
Model G1015 (Mfg. since 7/99)
The sanding arm assembly tilts to a horizontal
position, as shown in
Figure 25. This arrange-
ment is more convenient for certain types of sand-
ing or grinding operations.
Figure 25. Sanding arm assembly in the
horizontal position.
To position the sanding arm assembly hori-
zontally:
1. DISCONNECT MACHINE FROM POWER!
2. While holding the arm assembly, loosen the
two set screws in the round housing of the
pivot arm.
3. Pivot the assembly to the desired angle, then
re-tighten the pivot arm set screws to secure
it in place.
4. Adjust the tool rest in the position that is cor-
rect for your operation.
Note: If you will be using the contour of the
drive wheel for sanding or grinding, remove
the tool rest assembly so that it will not inter-
fere with the operation. Otherwise, you will
need to mount it differently so that it will not
interfere with the sanding belt.
5. Check and adjust, if necessary, the sanding
belt tracking (refer to
Adjusting Sanding Belt
Tracking on Page 21 for detailed instruc-
tions).
Auxiliary
Attachments
The auxiliary arbor accepts buffing, polishing, or
sanding attachments with a
5
⁄
8
" bore and up to a
10" diameter. Refer to Accessories on Page 24
for options from Grizzly.
When mounting buffing wheels, sandwich them
between the auxiliary flanges before sliding them
onto the left side arbor, as shown in
Figure 26,
then install the
5
⁄
8
" left-hand thread auxiliary arbor
nut to secure it in place.
Figure 26. Buffing wheel installed.
Arbor
Nut
Flange
Note: The installation of attachments other than
buffing wheels do not require the flanges.
Make sure that you ease the workpiece into the
attachment on the bottom front contour, as illus-
trated in
Figure 27.
Wheel
Rotation
Incorrect
Correct
Figure 27. Using the bottom front contour of the
attachment.