Grizzly G0869, Руководство пользователя, Страница: 53 / 72

Model G0869/G0870 (Mfd. Since 01/19)
-51-
Setting 45° Stop Cam
1. DISCONNECT MACHINE FROM POWER!
2. Raise blade as high as it will go, then tilt it
towards 45° until it stops and cannot be tilted
any more.
3. Place a 45° square against table and blade
so it contacts blade evenly from bottom to
top, as shown in
Figure 83. Make sure a
blade tooth does not obstruct placement of
square.
Figure 83. Checking blade at 45°.
Blade
45° Square
Table
— If blade is 45° to table, then no adjustment
to stop cam is necessary. Make sure tilt
scale pointer shown in
Figure 80 on Page
50 points to 45° mark on scale. If neces-
sary, adjust position by loosening adjust-
ment screw, moving pointer with your
fingers, then tightening screw.
— If blade is not 45° to table, adjust 45° stop
cam in similar manner as adjusting 90°
stop cam (see
Steps 4–9 of Setting 90°
Stop Cam, starting on Page 50.
5. Loosen stop cam adjustment screw (see
Figure 82) just enough so cam can be rotat-
ed without it slipping out of position.
6. Insert tip of Phillips head screwdriver into a
cam adjustment hole (see Figure 82) and
move cam slightly up or down as necessary
to adjust where blade tilt will stop.
— Rotate cam adjustment hole up to move
stop farther to left.
— Rotate cam adjustment hole down to
move stop farther to right.
7. Tighten stop cam adjustment screw to secure
adjustment.
8. Tilt blade toward 90° until handwheel con-
tacts stop cam, lock blade tilt setting, then
recheck to see if blade is square to table (see
Step 3 on Page 50).
9. If necessary, repeat Steps 4–8 until blade is
perfectly square to table when handwheel is
contacting 90° stop cam.
Figure 82. Location of 90° cam adjustment
screw and adjustment holes.
Adjustment
Hole
Adjustment
Screw