Grizzly G0849, Руководство пользователя

Страница: 26 / 56

-24-
Model G0849 (Mfd. Since 01/19)
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine and
connect to power source.
2. Lock casters so machine will not move.
3. To prevent tripping circuit breaker or sup-
ply fuse, connect machine to dust-collection
system and restrict airflow by partially closing
blast gates to limit motor amperage draw dur-
ing test run.
Note: If a dust-collection system is not avail-
able, you may also restrict airflow by install-
ing an 8" blast gate or reduction pipe on the
dust port, or by partially blocking the dust
intake port with a wooden board.
4. Stand away from intake port, then press ON
button on control panel (see Figure 40) to
turn dust-collection motor
ON.
— Dust Collection Indicator and Power
Indicator should illuminate, and motor
should run smoothly with little or no vibra-
tion or rubbing noises.
5. Press OFF button to turn dust-collection
motor
OFF (see Figure 40).
— If you suspect any problems, immedi-
ately turn machine OFF and disconnect it
from power. Refer to
Troubleshooting on
Page 42. If you cannot resolve the prob-
lem, contact our Tech Support at (570)
546-9663 for assistance.
Figure 40. G0849 dust-collection motor OFF and
ON buttons and indicator lights.
OFF
Button
ON
Button
Dust Collection
Indicator
Power
Indicator
The Test Run consists of verifying the following:
1) The main motor powers up and runs correctly,
2) the main motor shuts down correctly, 3) the
filter cleaning brush motors operate correctly, and
4) the remote control functions properly.