Grizzly G0849, Руководство пользователя

Страница: 45 / 56

Model G0849 (Mfd. Since 01/19)
-43-
Symptom Possible Cause Possible Solution
Dust collector does
not adequately
collect dust or chips;
poor performance. 1. Collection bag is full.
2. Canister filter is clogged/at fault.
3. Ducting blocked/restricted.
4. Dust collector is too far away from the point
of suction, or there are too many sharp
bends in ducting.
5. Lumber is wet and dust is not flowing
smoothly through ducting.
6. Ducting has one or more leaks, or too
many open ports.
7. Not enough open branch lines at one time,
causing a velocity drop in main line.
8. Ducting and ports are incorrectly sized.
or dust collection system is improperly
designed.
9. Dust collector is undersized.
1. Empty collection bag.
2. Manually run filter cleaning brushes (
Page 36);
wash or replace canister filter ( Page 44).
3. Unblock restriction in ducting. A plumbing snake
may be necessary.
4. Relocate dust collector closer to point of suction;
remove sharp bends in ducting.
5. Process lumber with less than 20% moisture
content.
6. Seal/eliminate all ducting leaks; close unused lines
with blast gate.
7. Open 1 or 2 more blast gates to different branch
lines to increase main line velocity.
8. Install correctly sized ducts and fittings ( Page 26).
9. Install a larger dust collector.
Dust collector blows
sawdust into the air. 1. Duct clamps or filter bag is not properly
clamped and secured.
2. Cylinder or funnel seals/gaskets are loose
or damaged.
1. Re-secure ducts and filter bag, making sure duct
and bag clamp are tight.
2. Retighten all mounting and sealing points; replace
damaged seals/gaskets.
Remote control
does not operate
dust collector. 1. Machine is disconnected from power.
2. Remote control battery is weak or dead.
3. Receiver and remote are not registered or
paired.
4. A wall or barrier disrupts the radio
frequency, or controller is too far away.
1. Verify machine is connected to power source.
2. Replace battery.
3. Pair remote with receiver (
Page 41).
4. Move machine away from barrier; use remote within
75' of machine.
Dust Collector Operation