Grizzly G0835, Руководство пользователя

Страница: 58 / 79

Model G0799 G0800 (Mfd. Since 11/17)
-41-
4. Loosen headstock, then move it all the way to
tail end of lathe bed, as shown in Figure 52.
5. Retighten headstock to bed.
When outboard turning, ALWAYS use a
floor-mounted tool rest and keep tool in
contact with rest during all turning opera-
tions. Failure to do so could cause tool to be
pulled out of operator's control and ejected
at high speed.
Figure 52.
Typical outboard turning operation.
(Shown here with Model T27484 Bed Extension
and Tool Rest Riser Bushing.)
Sanding/Finishing
After the turning operations are complete, the
workpiece can be sanded and finished before
removing it from the lathe, as shown in
Figure 53.
Figure 53. Typical sanding operation.
Note: Whenever sanding or finishing, move tool
rest holder out of the way to increase personal
safety and gain adequate working room.
Wrapping sandpa-
per completely around
workpiece could pull
your hands into mov-
ing workpiece and may
cause serious injury.
Never wrap sandpa-
per or finishing materi-
als completely around
workpiece.
Sandpaper
Workpiece