Grizzly G0808, Руководство пользователя

Страница: 42 / 68

-40-
Model G0808 (Mfd. Since 11/15)
Headstock Reservoir
Oil Type ......Model T23963 or ISO 32 Equivalent
Oil Amount ................................................ 2
1
⁄
2
Qt.
Check/Add Frequency ...........8 Hrs. of Operation
Change Frequency ..................... Every 180 Days
The headstock has the proper amount of oil when
the sight glass is halfway full (see
Figure 66).
Tools Needed Qty
Screwdriver Phillips #2 ...................................... 1
Open-End Wrench 22mm .................................. 1
Hex Wrench 3mm .............................................. 1
Hex Wrench 6mm .............................................. 1
Drain Pan (1-Gallon or Larger) .......................... 1
To change headstock oil:
1. Run spindle at approximately 500 RPM for
approximately 10 minutes to warm headstock
oil.
2. DISCONNECT MACHINE FROM POWER!
3. Remove motor cover and fill plug (see
Figure 66).
4. Place drain pan on table under headstock.
Figure 66. Location of headstock oil sight glass
and fill plug.
Fill Plug Sight Glass
5. Remove cover plate from bottom of head-
stock (see Figure 67).
6. Remove drain plug (see Figure 67) from
underneath headstock and allow oil to drain
into pan.
Figure 67. Headstock drain plug
(headstock tilted 90° for clarity).
Drain
Plug
Follow federal, and state, and local require-
ments for proper disposal of used oil.
7. Replace drain plug.
8. Add oil until sight glass is halfway full, then
re-install fill plug, cover plate, and motor
cover.
9. Clean up any spilled oil to prevent slipping
hazards.
Cover Plate
Removed