Grizzly G0808, Руководство пользователя

Страница: 31 / 68

Model G0808 (Mfd. Since 11/15)
-29-
Head Tilt
When positioning head back to 0° after tilt-
ing it, you will need to tram it to ensure spin-
dle is precisely perpendicular to table for
proper drilling accuracy. Refer to Tramming
Spindle section on Page 48 for instructions.
The head tilts from 30° left to 90° right. The 0°
index pin locks the head perpendicular to the
table and must be removed before tilting the head.
A scale on the side of the head indicates the
angle of tilt (see
Figure 40).
To tilt head:
1. DISCONNECT MACHINE FROM POWER!
Figure 40. Head tilting controls.
Scale
Lock Nut
(1 of 3)
Hex Nut
0° Index
Pin
Tools Needed Qty
Screwdriver Phillips #2 ...................................... 1
Open-End Wrench 10mm .................................. 1
Open-End Wrench or Socket 24mm ................. 1
Small Hammer/Mallet ........................................ 1
2. Tighten hex nut on 0° index pin (see Figure
40) against headstock, which will force pin
out. Pull pin out of hole to allow head to tilt in
following steps.
Figure 41. Cover plate removed from bottom of
headstock (headstock tilted 90° for clarity).
Cover Plate
Removed
Lock Nut
(1 of 3)
4. Loosen three lock nuts (one on each side of
head and one inside head) that secure head
tilt setting (see
Figures 41–40).
5. With assistance from another person to sup-
port head, tilt head to desired position.
— If tilting head to an angle other than 0°
(perpendicular to table), use scale (see
Figure 40) as a guide for setting tilt angle.
— If returning head to 0° (perpendicular to
table), use scale as a guide. When head is
at 0°, re-insert index pin with hex nut, and
gently tap it with a small hammer or mallet
to seat it.
6. Retighten lock nuts from Step 4.
3. Remove cover plate from bottom of head-
stock (see
Figure 41).