Grizzly G0808, Руководство пользователя

Страница: 21 / 68

Model G0808 (Mfd. Since 11/15)
-19-
Assembly
3. Use Z-axis crank handle to just slightly lower
table.
Note: Only exert mild pressure when lower-
ing table during
Step 3, otherwise you could
damage knee by forcing it down against
lower brace (see
Figure 18).
4. Remove upper wooden brace, raise table
slightly, then remove lower wooden brace
(see
Figure 18).
To assemble machine:
1. Remove cap screw and washer that secure
Z-axis crank handle, then remove crank
handle, turn it around, and re-install it with
compression spring, as shown in
Figure 16.
Figure 16. Z-axis crank handle installed
correctly.
Cap Screw
& Washer
Z-Axis
Crank Handle
2. Loosen Z-axis table lock (see Figure 17).
Figure 17. Location of Z-axis table lock.
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To make sure the assembly pro-
cess goes smoothly, clean all parts that have any
heavy-duty rust preventative applied by the fac-
tory (if applicable).
The Model G0808 ships with an extra X-axis
handwheel and handle in case you choose not to
install the X-axis power feed. If you choose not to
install the X-axis power feed, skip those assembly
steps, and install the extra handwheel (with han-
dle) in its place, in a similar manner as the Y-axis
handwheel assembly steps on
Page 22.
Figure 18. Wooden shipping braces to be
removed during assembly.
Upper
Brace
Lower
Brace
Knee
Note:
If you choose to install the X-axis
power feed, continue to Step 6. If you choose
to NOT install the X-axis power feed, skip
ahead to
Step 16.
5. Install coarse downfeed lever shafts and
handles onto coarse downfeed hub (see
Figure 19).
Figure 19. Coarse downfeed lever shafts and
handles installed.
Lever Shaft
(1 of 3)
Lever Handle
(1 of 3)
Hub
Compression
Spring