Grizzly G0734, Руководство пользователя

Страница: 27 / 40

Model G0734/G0735 (Mfd. Since 12/15)
-25-
SECTION 5: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check:
•
Loose mounting bolts.
• Damaged saw blade.
• Worn or damaged wires.
• Any other unsafe condition.
Schedule
Cleaning the Model G0734/G0735 is relatively
easy. Vacuum excess wood chips and sawdust,
and wipe off the remaining dust with a dry cloth.
If excessive sawdust accumulates around the
motor, remove the arm guard and remove the
sawdust with a vacuum.
Cleaning
The upper and lower arms have two sleeve bear-
ings each that require lubrication with SAE 20 Wt
oil after every 8 hours of machine use.
Lubrication
3. Lay the saw on its side as flat as pos-
sible, then apply a generous amount of light
machine oil to the two cups around the bear-
ing ends. Let the oil seep into the bearings for
an hour or two.
4. Wipe off the excess oil, turn the saw over,
and repeat Step 3 to the remaining two bear-
ings.
5. Replace the plastic caps before beginning
operation to keep dust and debris from reach-
ing the bearings.
1. DISCONNECT MACHINE FROM POWER!
2. Remove the plastic caps over the sleeve
bearings to expose their ends (see
Figure
32).
To lubricate the sleeve bearings:
Figure 32. Plastic caps removed to expose
sleeve bearing ends.
Bearing Ends