Grizzly G0656, Руководство пользователя, Страница: 19 / 54

G0656 8" Jointer with Built-In Mobile Base
-15-
9.
Slide the motor upward, and place the V-belt
around the cutterhead pulley and the motor
pulley.
10.
Slide the motor down to rest on the V-belt.
11.
Place a straightedge against both pulleys
(
Figure 10 ) and check the alignment of
the two pulleys to make sure that they are
aligned and that the V-belt is straight up and
down (see
Figure 11
).
— If the pulleys are aligned, tighten the motor
bracket fasteners and go to Step 15 .
— If the pulleys are NOT aligned, perform
Steps 12–14
.
12.
Remove the V-belt and loosen the motor
mount fasteners (see
Figure 9)
.
Figure 11.
Pulleys aligned.
Cutterhead
Pulley
Motor
Pulley
���������
Figure 13 . Fence tilt lever installed.
18 . Slide the cutterhead guard shaft down through
the mounting hole on the table.
Note
: The guard may not fully seat in the hole
initially; however, rotating the guard will allow
the shaft to fully seat in the hole.
Figure 10
. Checking belt alignment.
13.
Shift the motor horizontally as needed to
align the motor pulley with the cutterhead pul-
ley, then replace the V-belt.
14.
Tighten the motor mount fasteners.
15.
Secure the infeed and outfeed handwheels
with the cap screws and flat washers already
mounted on the handwheel shafts, as shown
in
Figure 12 .
16. Secure the handwheel handles to each of the
the handwheels, as shown in
Figure 12.
17
. Install the fence tilt lever, as shown in
Figure
13 .
Figure 12. Securing the handwheel handle.
Straightedge