Grizzly G0580, Руководство пользователя, Страница: 42 / 64

-40-
Model G0580 (Mfd. Since 11/06)
One of the benefits of a bandsaw is its ability to
cut multiple copies of a particular shape by stack-
ing a number of workpieces together. Before mak-
ing stacked cuts, ensure that the table is perpen-
dicular (90°) to the blade—otherwise, any error
in this setting will be compounded in the upper
workpieces.
To complete a stacked cut:
1. Align your pieces from top to bottom to
ensure that each piece has adequate scrap
to provide a clean, unhampered cut.
2. Secure all the pieces together in a manner
that will not interfere with the cutting. Hot
glue on the edges works well, as do brad
nails through the waste portion. (Be careful
not to cut into the brads or you may break the
blade!)
3. On the face of the top piece, lay out the
shape you intend to cut.
Figure 50. Example of a stacked cut setup.
Stacked Cuts
4. Make relief cuts perpendicular to the out-
line of your intended shape in areas where
changes in blade direction could strain the
woodgrain or cause the blade to bind.
5. Cut the stack of pieces as though you were
cutting a single piece. Follow your layout line
with the blade kerf on the waste side of your
line (see the figure below for an example of
stacked cut setup).