Grizzly G0453W, Руководство пользователя

Страница: 20 / 76

-18-
G0453W/ZW–G0454W/ZW (Mfd. Since 05/16)
Assembly
To assemble planer:
1. G0453W & G0453ZW: Attach each table
extension wing to planer table with (2) pre-
installed M8-1.25 x 25 cap screws, 8mm lock
washers, and 8mm flat washers,. Do not fully
tighten cap screws at this time.
G0454W & G0454ZW: Attach each table
extension wing to planer table with (4) pre-
installed M10-1.5 x 25 cap screws, 10mm
lock washers, and 10mm flat washers (see
Figure 15). Do not fully tighten cap screws at
this time.
3. G0453W & G0453ZW Only: Remove one
pre-installed hex nut from each table locking
rod, then install table lock star knobs on lock-
ing rods (see
Figure 16).
Note: Pre-installed hex nuts on table locking
rods are for shipping purposes only and may
be discarded after removal.
2. Using a straightedge as a guide, and table
adjustment set screws and cap screws for
leveling control, position extension wings
even with table and fully tighten cap screws
from
Step 1.
Note:
Be aware that bed rollers will give you
a false reading with your straightedge if they
are raised above table. Move them down or
work around them when leveling extension
wings (refer to
Bed Roller Height on Page
26 for more information).
Figure 15. Front extension wing installed
(Model G0454ZW shown).
Adjustment
Set Screws
(1 of 2)
Adjustment
Cap Screws
Figure 17. Handwheel and T-knob installed.
Handwheel
Handle
Feed Rate
Knob
4. Thread handwheel handle into handwheel
(see
Figure 17).
5. Thread feed rate knob onto feed rate shaft
(see Figure 17).
6. Secure handwheel on shaft with pre-installed
M5-.8 x 16 cap screw and 5mm flat washer
(see
Figure 17).
Figure 16. Table lock star knobs installed.
Table Lock
Star Knobs