Grizzly G0453W, Руководство пользователя

Страница: 23 / 76

G0453W/ZW–G0454W/ZW (Mfd. Since 05/16)
-21-
Test Run
To test run machine:
1. Clear all setup tools and loose objects away
from machine.
2. Push STOP button in.
3. Connect machine to power supply.
4. Twist STOP button clockwise until it springs
out (see Figure 24). This resets the switch so
the machine can start.
Figure 24. Resetting the switch.
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
Recommended
Adjustments
The adjustments listed below have been per-
formed at the factory. However, because of the
many variables involved with shipping, we recom-
mend that you at verify the adjustments to ensure
the best possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in the
SERVICE section starting on
Page 37.
Factory adjustments that should be verified:
• Check V-belt tension (
Page 40).
• Calibrating table height scale (
Page 46).
• Pulley alignment (
Page 47).
5. Press START button to turn machine ON.
Verify motor starts up and runs smoothly
without any unusual problems or noises.
6. Press STOP button to turn machine OFF.
7. WITHOUT resetting STOP button, try to start
machine by pressing the START button. The
machine should not start.
— If the machine does not start, the STOP
button safety feature is working correctly.
Congratulations! Test Run is complete.
— If the machine does start (with the STOP
button pushed in), immediately disconnect
power to the machine. The STOP button
safety feature is not working correctly and
must be replaced before further using the
machine. Call Tech Support for help.
After approximately 16 hours of operation,
V-belts will stretch and seat into pulley
grooves and need to be properly tensioned
to avoid severely reducing life of V-belts.
Refer to Tensioning/Replacing V-Belts on
Page 40 for detailed instructions.