Grizzly G0453W, Руководство пользователя

Страница: 42 / 76

-40-
G0453W/ZW–G0454W/ZW (Mfd. Since 05/16)
Tensioning/
Replacing V-Belts
After approximately 16 hours of operation,
V-belts will stretch and seat into pulley
grooves and need to be properly tensioned
to avoid severely reducing life of V-belts.
Three V-belts transfer power from the motor to the
cutterhead, and then to the infeed and outfeed
rollers with the use of the drive chain system. To
ensure efficient transfer of power to these sys-
tems, make sure the V-belts are always properly
tensioned and in good condition.
If the V-belts are worn, cracked, or damaged,
replace them. Always replace the V-belts with a
matched set of three, or belt tension may not be
even among the belts, causing premature belt
failure.
V-belts and pulleys will be hot after opera-
tion. Allow them to cool before handling.
Tools Needed Qty
Phillips Screwdriver ........................................... 1
Open-End Wrench 18mm .................................. 1
To tension/replace V-belts:
1. DISCONNECT MACHINE FROM POWER!
2. Remove V-belt cover from left side of machine
to expose belts, as shown in
Figure 58.
Note: A collection of black belt dust at the
bottom of the belt cover is normal during the
life of the belts.
3. Remove front cabinet cover to access motor,
as shown in
Figure 59.
Figure 59. Front cabinet cover removed to
access motor.
Motor Mount
Hex Nuts
Figure 58. Belt cover removed to expose V-belts
and pulleys.
V-Belts
Cutterhead
Pulley
Motor
Pulley