Grizzly G0449, Руководство пользователя

Страница: 22 / 80

-20-
Model G0449/G0450 (Mfd. Since 8/13)
Gear Oil Check
To check the gear oil:
1. Check the sight glass shown on the back of
the gear box to make sure gear oil is present,
as shown in
Figure 19.
Figure 19. Typical vented fill plug (sight glass
not shown).
2. If the gearbox oil level is low, follow the steps
on
Page 31 to refill the oil.
Sight Glass
Gear Box
Before starting the sander, make sure you
have performed the preceding assembly
and adjustment instructions, and you have
read through the rest of the manual and
are familiar with the various functions and
safety features on this machine. Failure to
follow this warning could result in serious
personal injury or even death!
Test Run
Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
The test run consists of verifying the following:
1) The motors power up and run correctly, 2)
the motors turn the correct direction (machine is
not wired out of phase, G0450 only), and 3) the
EMERGENCY STOP button safety feature works
correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 33.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure you understand the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure the feed motor gearbox is full of
oil and the shipping seal is removed from the
vented fill plug.
3. Ensure all tools and objects used during
setup are cleared away from the machine,
and all covers and panels are closed.
Vented
Fill Plug