Grizzly Tools G1026, Инструкция по эксплуатации

Страница: 18 / 29

15
17
2. Remove the V-belt.
3. Loosen the locking bolt on the spindle slide
shown in
Figure .
4.
The bearing housing will drop down. If you
need to spread the casting more, use a
screwdriver.
Figure 15. Locking bolt on spindle slide.
Use care when spreading the casting—it will
break if too much pressure is applied. When
the casting is spread, the housing can fall
down. Watch your fingers to avoid being
pinched. Place a pad underneath to protect
the housing from being damaged if it falls.
5. Remove the spindle and replace the bear-
ings inside the bearing housing. If you need
pointers regarding bearing replacement, call
our service department.
6.
To slide the housing back in, reverse the
procedure. Make sure the locking bolt is
tightened securely.
SECTION 6: SERVICE ADJUSTMENTS
Keep clothing rolled
up and out of the way
of machinery and keep
hair pulled back.
Wear safety glasses dur-
ing the entire adjustment
process. Failure to com-
ply may result in serious
personal injury.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
Pulley Alignment
Improper pulley alignment sharply reduces the
effectiveness of power transmission and belt life
expectancy.
To align the pulleys:
1.
DISCONNECT SHAPER FROM POWER
SOURCE !
2. Open the motor cover on the side of the
shaper cabinet.
3.
Check the alignment with a straightedge. If
the pulleys are in alignment, the straightedge
should touch two sides of each pulley evenly.
See Figure 16.