Grizzly Tools G1026, Инструкция по эксплуатации

Страница: 17 / 29

SECTION 5: MAINTENANCE
16
Spindle Moulder should be protected against rust
eplace when necessary.
it. Check for the following conditions and repair or r-
a habit of inspecting your shaper each time you use
oulder will ensure its optimum performance. Make
Regular periodic maintenance on your Spindle M-
V-Belt
Avoid getting grease or oil on the V-belt or pul-
leys.
Check the V-belt, as part of your monthly inspec-
tion, for proper tension and belt condition. Cracking
and glazing could result in belt failure. Replace
the belt if such conditions appear.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged V-belt.
5. Any other condition that could hamper the
safe operation of this machine.
General
Table
The table and other non-painted surfaces on the
and pitting. Wiping the table clean after every use
ensures that wood dust isn’t allowed to trap mois-
ture against bare metal surfaces.
Lubrication
The only parts on this machine that require peri-
odic lubrication are the ways where the cartridge
slide rides on the elevation housing and where the
worm gear and bushing are located. Use a light
grease or anti-seizing compound on the ways
and worm gear and give the shaft mount a shot
of light oil. The frequency of lubrication depends
on the amount you use the shaper. As a habit,
inspect the machine at least once a month.
Wear safety glasses dur-
ing the entire mainte-
nance process. Failure
to comply may result in
serious personal injury.
Spindle Moulder features factory-sealed bearings.
damage to other parts of the machine.
Spindle Bearings
The spindle bearing housing equipped with the
A sealed bearing requires no lubrication during
its lifetime.
Should a bearing fail, your shaper will probably
develop a noticeable rumble that will increase
when the machine is put under load. If allowed to
get worse, overheating of the journal containing
the bad bearing could occur. If the bad bearing
You must remove the complete bearing housing
assembly to replace the bearings.
is not replaced, it will eventually seize—doing
To remove the bearing housing assembly:
1.
DISCONNECT SHAPER FROM POWER
SOURCE!