94
GB
• When the saw chain (20) is tensioned
with 9 N (approx. 1 kg), the gap be
-
tween the saw chain and the blade
(21) may not be more than 2 mm.
H
1. Turn blade fixing screw (23) anti
-
clockwise to slightly loosen blade
(21).
2. Set the tension of saw chain (20)
using chain tensioner (
34).
- Turn the chain tensioner
clock-
wise
to increase the tension.
- Turn the chain tensioner
anti-
clockwise
to decrease the ten-
sion.
3. Turn blade fixing screw (23) to
retighten blade (21).
Where saw chain (20) has been
newly tensioned, readjust the
chain tension after a short period
in operation.
Check the chain tension before
each use of the electric
pruner.
Filling up with chain oil
Blade and saw chain must always
be oiled. Non-observance of this
will result in increased wear on the
blade and saw chain.
• Check the oil fill level in the oil level
inspection window and regularly top up
with chain oil.
• Use bio-oil; this product contains addi-
tives that reduce wear and tear and does
not damage the pump system. bio-oil is
available from our Service-Center.
• If you have no Grizzly bio-oil available,
use chain lubrication oil with low adhe-
sive additive content.
1. Unscrew the oil fill cap (
A
26) and fill
up with chain oil.
2. Wipe off any spilled chain oil and close
the cap again.
Note that the saw can re-oil.
Sawing techniques
• Be thoroughly aware of the danger of
rebounding branches.
Sawing Off Small Branches
Set your saw cut of
smaller branches
(Ø 0-8 cm) from top
to bottom, as illus-
trated.
Be aware of early
breaking of the
branch if you have
underestimated the size and weight. Be
completely aware of the falling cut material
Sawing Off Larger Branches
For controlled saw-
ing of larger branch-
es (Ø 8-25 cm)
, first
select a relief cut
(see cutting a).
This is made from
below. Saw a notch
in the lower third
of the branch. The
actual length cut (see cutting b) is again
made from the top, as far as possible in
line with the first cut so that the two cuts
meet.
Sawing Off Parts
c
b
a
For large/long
branches, sawing
off in parts is recom
-
mended (see cutting
a, b, c).
This is the only way
to safely ensure the
point of impact of the cut material.
Clear away from the area in which you are
standing any parts that have already been
cut and are lying on the ground.
Содержание EHS 900-2 L
Страница 3: ...3 D E G I F H 5b 5b 11 5a 5a 4 6 6 4 7 21 20 36 23 28 24 23 21 20 33 34 21 35 37...
Страница 158: ...158...
Страница 164: ...164...
Страница 168: ......