Grizzly Tools EHS 600-59, Перевод оригинальной инструкции по эксплуатации

Страница: 66 / 128

66
GB
lows the hedge to thrive optimally.
During cutting, only the new an-
nual growths are reduced and thus
a dense branching and a good
screen will develop.
1. Cut the sides of a hedge first. To do
this, move the hedge trimmer in the
direction of growth from bottom to
top. If you cut down from the top, the
thinner branches will move out, which
may result in some areas having
sparse growth or holes.
2. Cut the top edge, according to taste,
in a flat shape, roof shape or rounded
shape
3. Trim young plants to the required
shape. The main growth should re-
main undamaged until the hedge has
reached the planned height. All other
shoots are lopped off to half size.
Care of Free-Growing Hedges:
Free-growing hedges are not shaped
when cut, although they must be regularly
maintained so the hedge does not be-
come too high.
Cutting Times
Deciduous hedges ........ June and October
Hedges of coniferous wood .........April and
August
Evergreen conifer hedges ..........from May
Maintenance/Cleaning
Pull out the power plug before car-
rying out any work on the equip-
ment.
Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Wear gloves while handling the
blades.
Carry out the following maintenance and
cleaning work regularly. This will guaran-
tee a long and reliable service life.
Do not spray the equipment with
water or place it in water. Do not
use detergents or solvents. These
could cause irreparable dam-
age to the equipment. Chemical
substances may attack the plastic
parts of the equipment.
• Before each use, check the hedge
trimmer for obvious defects such as
loose, worn or damaged parts. Check
the secure seating of the bolts in the
cutter bar.
• Do not use the unit if the blades are
blunt or worn. This will overstress the
motor and gearbox of the machine.
• Check coverings and safety devices
for damage and correct seating. Re-
place these where necessary.
• Keep the ventilation slots and motor
housing of the device clean. Use a
damp cloth or a brush to do this. Do
not wash down the equipment with
water, or submerge it in water.
• Clean the cutter bar carefully after
each use. Wipe it off with an oily cloth
or spray it with a metal protective
spray.
• Keep the hedge trimmer dry and
covered with the blade protection sup-
plied and out of reach of children.
• Keep the hedge trimmer dry and out
of reach of children in the blade guard
supplied.