Griven GR0399, Инструкция по эксплуатации

Страница: 32 / 40

D. Tighten the lamp “16” in the lamp socket.
E. Close the lamp holder “13” and connect the lamp
cable to the clamp “17” and lock the cable to the lamp
holder by using the metal lockers.
F. Close the front panel by tightening the two screws “11” previously removed.
7.3 Lamp alignment
When replacing the lamp with a new one, it is recommend to verify the lamp alignment to the optical system to
obtain the maximum uniformity and luminous performance by the projection.
• Install the new lamp and switch it on
• Point the fixture at a flat surface (if possible white or light coloured) at least 20 metres from the fixture.
• Set the control channels to obtain a white beam. Then set the dimmer fully open, focus correctly and do not
project colours.
Use the button “18” to align the lamp to the Y axis.
Use the button “19” to align the lamp to the x axis.
18
19
Attention!
Insert the lamp wire terminals in the clamp “17”,
centering it with the closing screw. Tighten carefully the
screw with the help of an hexagonal headed bolt. Make
sure to perform such connection properly in order to
avoid damages to the wire and the lamp itself.
17
16
32 English