Griven GR0399, Инструкция по эксплуатации

Страница: 30 / 40

7.1 Lamp specifications
Kolorjet 4000 is designed exclusively for use with OSRAM XStage 4000 W.
The lamps are part of the Xeno family of discharge lamps and must be handled with great care. The lamp oper-
ates at high pressure, and the slight risk of explosion of the lamp exists if operated over its recommended life. We
recommend, therefore, that the lamp be replaced within the manufacturer’s specified lamp life.
At every lamp change, reset the lamp life counter using the unit control panel. This help you to remember when
replacing the lamp.
The lamp specification, available via your Griven distributor, are shown in the table below.
7.2 Lamp installation
Attention!
Disconnect the unit from mains supply before servicing it or performing any other action.
The lamp is very hot during operations! Wait at least for 30 minutes before changing.
Wear all necessary protective garments to handle the Xenon lamp (gloves, protective mask, etc.)
Lamp is to be replaced exclusively with the unit positioned vertically, as per following picture.
Lamp OSRAM XStage 4000 W
Griven code LP1026
Rated lamp wattage 4000W
Rated lamp voltage 30V
Rated lamp current 130A
Current control range 80A - 135A
Ignition voltage 36.000V
Luminous flux 150.000 lm
Average service life 1000 h
Base (cathode) SFc 28-27
Base (anode) SFaX 27-9.5
Attention!
Installing any other lamp may create a safety hazard or damage the fixture!
7.0 Lamp installation and replacement
30 English