Griven GR0399, Инструкция по эксплуатации

Страница: 29 / 40

6.3 Connection to DMX signal
The unit is fitted with sockets XLR3 IP65, for DMX input and output.
Connected the fixture to a DMX controller by using the
socket “10” .
To connect the DMX signal or the line terminal plug,
EXCLUSIVELY the XLR3 IP65 connectors enclosed to this
manual are to be used, in order to preserve the IP65
weather protection rate.
The DMX signal is to be connected by using a shielded
cable designed for devices RS-485 with minimum section
of 0.35 mm².
The signal cable must be connected according to the fol-
lowing table:
pin 1 = GND
pin 2 = data -
pin 3 = data +
For DMX devices with 5 poles connectors, pins 4 and 5 are
not to be connected.
Warning!
All data wires must be isolated one from another, from the shield and from the metal housing of the connectors.
Pin number 1 of the housing is not to be connected to the electric ground of the unit.
Insert a terminal plug with a 120 Ω resistor connected to pins 2 and 3 in the last unit.
Pin 1: GND
Pin 2: DATA-
Pin 3: DATA+
10
English 29