GripOne CHRONO TC, Руководство пользователя

Страница: 7 / 12

www.gripone.com
Important
If the fixing screws of the brake disc are hollow head (as allen
screws), replace them with flat head screws. If you can not replace
the screws, place the sensor to detect only the outer edge of the
screw (like it is shown in the side picture).
Each screw detected by the sensor must be equidistant from the
others. The screws may be of iron or steel. If these conditions are
not met the sensors may not work properly.
After completing the installation of the sensors, turn on the
controller and turn the wheels. As the wheel turns in the sensors
verify that the led to the passage of each screw.
5.0 Configuration of unit
GRIPONE has 2 buttons (OPTION and MENU) through which you can configure the unit. When
the unit is turned on (and bike is stop), you can access the menu by pressing the MENU button.
Press MENU button to scroll through all the configuration parameters, up to return to the main
screen. For each parameter you can change its value by pressing the OPTION button. Every time
you press OPTION button, the value of selected parameter will change from its minimum to its
maximum (and back to minimum like a loop). After few seconds that you don’t press any button,
the ECU goes back automatically on the main screen.
5.1 Menu
Pressing MENU button you can scroll each configuration parameter.
MAIN SCREEN – when the unit is on and ready , you can read on the LCD the following text:
MAP TC: 00001
Controls: ON
The first row show the selected traction control map (00001, 00002 or 00003). The second row
show the status of control system (ON or OFF). In the main screen you can press OPTION button
to change the map (1, 2 or 3). Keep pressed both buttons for 4 second to switch ON or OFF the
system
TC SENSITIVE – it change the sensitivity of traction control. Bigger is the number of TC
SENSITIVE and more the system will be fast to react to the sliding.
Set 15 to start
TC CONTROL – it control the progression of traction control. If you want to stop quickly the
spinning (strong effect of traction control) use high values (12 to 20). If you want a soft effect of
traction control use a small values (1 to 8).
Set 10 to start
AW SENSITIVE – This parameter fix the sensitivity of anti wheelie control. Increase this value if
you want to reduce the power as soon the tyre lift from the ground. Reduce this value if you want
to permit a bit of wheelie after the tyre is lifted from the ground. Set 15 to start