SINEWAVE GRINFINEON CONTROLLER MANUAL
Rev 2.1
-5-
Figure 3: Basic hookup diagram (motor, throttle, and battery)
The throttle is a 3-pin JST-SM plug intended for Hall Effect throttle devices. It
supplies 4.3V to power the throttle plug and expects a signal of 0.9V - 3.6V as
the throttle is twisted. Throttle signal voltages higher than 4.0V are considered a
fault condition, so if a potentiometer based throttle is used then appropriate
resistors are needed to keep the voltage swing within range.
Figure 4: Controller Throttle Pinout
